Hello there lads and lasses,
I haven't been on this forum for a while because of my exams, but now I'm back and back down in da hood!

So, I recently bought myself an A600 and a few bits and bobs, intending to install a hard disk I could salvage out of my dead A1200. Well, everything goes smoothly, and fits together like it's meant to, untill, that is, I, alas, turn the A600 back on:

Now, you see, the picture on the screen wobbles and waves, and the colours are murkier and everything. I made sure the hard drive cradle wasn't shorting anything on the circuit board, because it had caused some problems before, but that wasn't the problem.

This tutorial shows the A1200 with some shielding between the disk and the modulator, so I asked myself whether this could be a shielding problem.

What do you reckon, lads and lasses?