A1200 IDE

[Buleste]

I think it will fit a 1200 but JLPedro was trying to put it in the wrong way round. I've looked at the picture and there is a number 1 just below the black wire which i think corresponds with the number 1 on the 2.5 ide on the 1200 so the protruding wires should be near the PCMCIA slot and the side with JLpedros thumb should just about fit next to the TV tuner. If i remember rightly the numbers for the 2.5 pins and 3.5 pins were mirrored so that you couldn't damage a 2.5 drive by trying to fit it to a 3.5 connector.

[JLPedro]

Forget it, i've managed to broke-it triyng to cut the edges to fit de board so i'll buy a buffered interface for the amiga 1200 like this:

http://amigakit.leamancomputing.com/...4f4ac33de71b21

By the way, is it any good just to fit a 3,5 HD drive?