MerfPJ
3rd January 2009, 19:04
Hello
I am trying to make an hard-dirve ready for my A600, I am following this guide "wiki(dot)classicamiga(dot)com/How_to_install_SFS_onto_a_real_Harddrive_within_WinUAE" I'm using Windows xp home service pack 3 and winuae version 1.5.3, every thing runs fine, but my problem is when i get to the part where i shall reboot the system then it goes wrong, I get a message at the start up saying "Program failed (error #80000004) Suspend? Reboot?" if I press suspend it only hangs and if I press reboot it reboots but the same message turns up again. Sow now I'm stuck :(
The hard-drive is an 3.5 ide with 800mb, I have to format it to fat or ntfs, because windows wont load if its not.
Sorry for the bad English, I'm from Denmark
I am trying to make an hard-dirve ready for my A600, I am following this guide "wiki(dot)classicamiga(dot)com/How_to_install_SFS_onto_a_real_Harddrive_within_WinUAE" I'm using Windows xp home service pack 3 and winuae version 1.5.3, every thing runs fine, but my problem is when i get to the part where i shall reboot the system then it goes wrong, I get a message at the start up saying "Program failed (error #80000004) Suspend? Reboot?" if I press suspend it only hangs and if I press reboot it reboots but the same message turns up again. Sow now I'm stuck :(
The hard-drive is an 3.5 ide with 800mb, I have to format it to fat or ntfs, because windows wont load if its not.
Sorry for the bad English, I'm from Denmark